How to Enable Immo and Programming in Consult 3 plus

  • -

How to Enable Immo and Programming in Consult 3 plus

Consult-3-Plus-2

Here is how to use Nissan Consult 3 Plus to do Immo and programming without spending out on the smart card.
find the consult diagnostictool.ini file
open with notepad
copy and paste this at the bottom

——————————————————–
[mode]
debug_mode=TRUE
debug_mode_vehicle-battery=TRUE
[vehicles]
tab_index=0
———————————————————
ALSO, MAKE SURE ACCESS_MODE IS SET TO 1 IN THIS FILE

NOW SAVE AND REOPEN CONSULT…VOILA!!!!!

Here is the location of fille DIAGNOSTICTOOL.INI:

C:\CONSULT-III_plus\System\Application\ApplicationData\CommonSetting\DiagnosticTool.ini

Please just try this at your own risk, I am not responsible the result if you have any question.

I share this because you can do this without spending money to buy the security card.

And this solution is for Car Scanner consult 3 plus.

If you can’t solve this problem, better buy consult 3 plus+ security card for IMMO AND PROGRAMMING.


  • -

Tips on Nissan Consult III plus ECU programming

I try to program a new blank engine ECM on a 2013 Nissan Armada. I purchased the software file from Nissan website and one Nissan Consult III Plus . I do not have Consult online synchronized with Assist. At first, I have no idea what folder to put this file in so Consult program will find.

26-1

I used ners and nissan file extracted to correct folders by it self. used unpack.exe
anyway here you go 6) For CONSULT III plus “Blank” ECU (ECM and non-IK TCM) Programming

Note 1: Before using this application, you will need to put the “programming” data file (*.dat) and the
management csv file you received with the download, in the C:\ReproProgramming folder (see screen capture
above under item # 5). Without the programming data and the management csv file in this folder, the C-III plus
application will not identify or display the applicable programming. The C-III plus software will check the part
number of the ECU on the vehicle and display the reprogram to be installed.
NOTE 2: If this is the first time using C-III plus for reprogramming, you may need to make the
C:\ReproProgramming folder. C-III plus does not automatically create the folder