Use Launch X431 PAD V (PAD 5) or X431 PAD VII (PAD 7) to work with X-431 ADAS PRO or X-431 ADAS Mobile will make the calibration work so much easier.
Car model:
Ford F-150 2019
Device recommended:
Launch X431 PAD V (PAD 5) with Smartbox 3.0 Full System Diagnostic Tool
2021 New X431 PAD VII Full System Diagnostic Tool with Smartlink C
Launch X431 ADAS Mobile
Launch X431 ADAS Pro
Operation guide:
Step 1: Select the corresponding car make>> Automatically search (Software version: Ford V48.50 or above)
Step 2: Confirm the vehicle information detected out
Step 3: Select Special Functions or ADAS (Advanced Driver Assistance System) Calibration>> Electrical>> Cruise Control>> CCM#1 (Cruise Control Module) Calibration
Step 4: Follow the on-screen prompt to confirm the conditions that need to be met
Step 5: The X431 PAD VII scanner will prompt that a Fault Code will be generated when the ignition is switched OFF before the calibration is complete.
Step 6: Drive the vehicle between 50 and 80 kph to perform the radar calibration. Keep driving until “Front sensor is not aligned” disappears. If the vehicle is equipped with stop/start, please manually disable it before you start driving.
Step 7: When the process is done, you will get a prompt that the function executed successfully.
Step 8: Exit the calibration menu then clean down any fault codes.
Done!